Short: Stores raw contents of clipboard(s) Author: Ralph Reuchlein Uploader: Ralph Reuchlein Type: util/misc Version: 1.0 Replaces: util/misc/StoreClips.lha Architecture: m68k-amigaos Kurz: Speichert Clipboardinhalt(e) StoreClips ========== PURPOSE Stores the contents of clipboards to files. There are different ways to specify clipboard units you want to store. Each clipboard is stored in its according file called "T:clipboard.xxx", where xxx is the number of the unit. For instance, if you store clipboard unit 0, you'll get a file called "T:clipboard.000". Empty clipboard units will not be stored (there's simply no file for it). The program will inform you which unit has been stored in a file. In most cases you'll get IFF files, because its recommended to use IFF structures within the clipboards. The program cannot set clipboard contents! It simply stores the contents and thats all. USAGE SYNTAX: StoreClip [start [end]] Possible combinations: · StoreClip This will store all the 256 clipboard units to the files "T:clipboard.000", "T:clipboard.001", ..., "T:clipboard.255". Note that empty clipboards don't generate files. If you are using the standard clipboard mechanism in all the programs, you might only get one file for unit 0 called "T:clipboard.000". · StoreClip start This only stores the clipboard with number 'start'. Acceptable values are between 0 and 255. The resulting file will be "T:clipboard.". · StoreClip start end This allowes you to limit the range for storing clipboards. For instance StoreClip 0 9 only will store the clipboards 0 to 9 to the according files (if something is in them) · StoreClip ? Simply shows you the syntax. DISCLAIMER THIS SOFTWARE IS PROVIDED BY THE AUTHOR AND CONTRIBUTORS "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE AUTHOR OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. MISC The archive contains the source code, an executable and this .readme file. All of them are ©ed by me. Compiled with SAS/C 6.58 with no special parameters, so I believe that using another compiler only leads to varying the include file names. Suggestions are welcome, but I don't think about extending the program, because the purpose of storing the contents is fully accomplished. CONTACT Ralph Reuchlein [updated 30-May-2020 because neither address nor email was valid]